Daily maintenance of submersible axial flow pump

Submersible axial flow pump is a submersible pump with axial flow working principle, which is characterized by large flow and low head, and the flow rate can reach tens of thousands of square meters per hour. The motor is multi-pole motor, low speed. Installation methods are mostly shaft type and sled type, often used in pumping stations, known as flood drainage tools!"

Mechanical equipment such as submersible axial flow pumps, no matter how good the quality is when purchased, can not ignore its daily maintenance work. On the one hand, daily maintenance is to prevent the occurrence of sudden stop or damage in the work of the pump, and on the other hand, it is also an effective way to extend the service life of the pump.

Inspection of appearance level

If you want to do a good job of maintenance and maintenance of sewage treatment plants, then there is no doubt that there is still a basic appearance inspection. Every year, the basic inspection of the submersible axial flow pump station can not be less, to clarify the centrifugal pump, Gershan, and its relative control system conditions, if there is damage, common faults and other problems, it is immediately adjusted.

Basic cleanup work in progress

Because the sewage treatment plant is usually touched by some waste water, so the internal situation is also to immediately carry out concern, in addition to do a good job in the basic removal work. For example, to do a good job of cleaning up the part of blue Geshan, but also to care about the condition of the water body, if the water body appears abnormal turbidity, then there is no doubt that it is necessary to pay attention to the basic cleaning work. It is less every quarter or should do a good job in the cleaning work, so that it can also have the actual effect of machine and equipment maintenance.

Remove the grease

Because there are many different parts in the submersible axial flow pump station, the lubrication work should also be done well, and the removal of grease should be carried out on time in accordance with the manufacturer's regulations, which can also prevent some excess damage problems. If it is possible to do a good job of basic lubrication and inspection, of course, it can also prevent some unnecessary common failures.